Engine Surface Degreaser Spray

Rating: Not Rated Yet

Description

 

MARPA® Engine Surface Degreaser Spray (M2000-1)

  • Cleans grease stains from the surface of the outer engine, without damaging its thin rubber or plastic components

DIRECTIONS

1) Turn on the car engine.

2) After a few minutes, turn it off as the engine warms up.

3) Remove the air filter, and cover the carburetor and the distributor.

4) Shake the can of MARPA Engine Surface Degreaser Spray severely before use. It is also necessary to shake the can periodically while spraying.

5) Spray MARPA Engine Surface Degreaser from 20-40 cm of the surface uniformly from top to bottom.

6) To spray MARPA Engine Surface Degreaser materials easier, try to hold the can vertically. Do not tilt it more than 45 degrees relative to an imaginary horizontal line. Try to keep the spray head upward.

7) After 5 minutes, wash the surface with clean water.


PRECAUTIONS

  • Use MARPA Engine Surface Degreaser Spray at a good ventilated space!
  • This spray contains pressurized flammable material; keep it in a cool and dry place (with a temperature lower than 45° C), with adequate ventilation, away from heat, flame, and direct sun light!
  • Do not put the can of MARPA Engine Surface Degreaser Spray near the front or back windshields; and keep it away from hot air outlet of the car!
  • MARPA Engine Surface Degreaser Spray tin can is recycled after it is completely used up!
  • Do not puncture, bend or incinerate the container of MARPA Engine Surface Degreaser Spray, even after it is fully used!
  • For eye contact, flush with clean water and consult a physician!
  • If swallowed, immediately induce vomiting and call a physician!
  • If skin contact made, wash with soap and water. If irritation develops or persists, consult a physician!
  • Keep MARPA Engine Surface Degreaser Spray out of reach of children and animals!

Reviews

There are yet no reviews for this product.
Vote MARPA Cleaners!
Excellent - 0%
Very Good - 0%
Good - 0%
Average - 0%
Bad - 0%

Total votes: 0
The voting for this poll has ended on: 07 Feb 2013 - 09:55